We provide specialized winterization services to safeguard your pool during the off-season, and when spring arrives, we handle the thorough opening process.
We provide specialized winterization services to safeguard your pool during the off-season, and when spring arrives, we handle the thorough opening process.
Absolute Pools provides pool leak detection and pool leak repairs in Doringkloof and nearby Centurion areas, helping homeowners, complexes, rental properties and managed properties find the cause of swimming pool water loss and repair it properly.
Doringkloof has many established homes with older pool areas, paved surrounds, lawns, gardens and pool systems that may have been repaired or resurfaced over the years. When these pools begin losing water, the issue can come from worn marbelite, cracked fittings, ageing plumbing, a leaking weir, pool lights, pipe joints or water escaping below paving before the source becomes obvious.
Pool leaks in Doringkloof can be tricky because the first visible sign is not always the real leak point. A wet patch near the pool edge may be caused by water moving underground from a pipe, fitting or crack somewhere else. A pump that pulls air may point to suction-side plumbing rather than the pool shell. A water level that keeps stopping at one height may point to a fitting, light, weir or tile line.
Absolute Pools checks the pool, pump system and surrounding area to narrow down the likely source of water loss. This may include the pool shell, tile line, fittings, lights, weir, return jets, suction points, pump area, visible plumbing, paving edges, wet soil and areas where water may be travelling below the surface.
The goal is to understand the leak before repair work begins, so the right area is repaired instead of opening paving or patching the wrong section.
Many Doringkloof pools have been in place for years. Some have older pipework, older fittings or marbelite that has become rough, thin or cracked over time. Others may have had small repairs done before, but the original leak cause may not have been fully solved.
A pool can also have more than one weakness. The surface may show wear, while the plumbing may also be ageing. The pump may still run, but air bubbles, weak suction or repeated priming problems may show that the system is not sealed properly.
For homeowners, this can become frustrating because topping up the pool may seem easier at first. But repeated top-ups waste water, dilute chemicals and can allow damage around paving, coping and garden areas to continue unnoticed.
A swimming pool can lose some water naturally during hot, dry or windy weather. But if the level drops quickly after filling, or if you need to top up the pool several times a week, there may be a leak.
Common warning signs include paving that stays damp, wet garden soil near the pool, loose coping, cracks in the pool surface, a pump that struggles to prime, air bubbles from the return jets, weak suction, stains near cracks, a noisy pump, or a water level that keeps settling around the same point.
Pool maintenance can also reveal a leak. If chlorine disappears quickly, the water balance keeps changing, or the pool becomes cloudy after frequent top-ups, treated water may be escaping and being replaced too often with fresh water.
In Doringkloof properties, pools are often close to lawns, paved entertainment areas, garden beds, boundary walls or older outdoor structures. Water escaping from a pool can move through soil, under paving or along garden edges before becoming visible.
This means a damp area may not show the exact leak point. A leak from a return line, suction line, pipe joint or fitting can surface away from the actual problem. The same can happen when water escapes from cracks or weak areas around the pool shell.
Early leak detection helps protect the pool area from further damage. It can reduce the risk of paving movement, soft soil, loose coping and repeated damp patches that return after every top-up.
Not every drop in water level means the pool is leaking. Doringkloof pools can lose water naturally when they are uncovered, exposed to full sun, affected by wind, heated or fitted with water features.
A leak becomes more likely when the water loss is steady and keeps happening regardless of weather. If the level drops every day, falls faster when the pump is running, or stops at the same level after each top-up, the cause should be checked.
If the level stops near the weir, return fitting, pool light or tile line, that area may need closer inspection. If the water keeps dropping below those points, the shell, lower fittings, main drain or deeper plumbing may be involved. If the water loss is worse while the pump is running, pressure-side plumbing or return lines may be part of the issue.
Underground plumbing leaks are one of the common causes of unexplained pool water loss. These leaks can happen in suction lines, return lines, waste lines, pipe joints or fittings between the pool and the pump system.
A plumbing leak may show through air bubbles from the return jets, weak suction, poor circulation, a pump that loses prime or water loss that becomes worse while the system is running. Sometimes the pool shell looks fine, but water is escaping from pipework below paving, lawn or garden areas.
In older properties, plumbing routes may not be obvious. The pump may be positioned away from the pool, or pipes may run below paving and landscaped sections. Checking the system behaviour helps narrow down whether the problem is likely to be plumbing-related.
Pool surfaces should be checked when there is ongoing water loss. Marbelite can become rough, hollow, thin or cracked with age. Fibreglass can leak around fittings, damaged patches or stressed sections. Concrete and tiled pools can leak through cracks, weak joints, tile lines, failed grout or poorly sealed fittings.
A visible crack should not be ignored when the pool is losing water, but it should not automatically be treated as the only cause. The pool may have a surface problem, a fitting problem, a plumbing problem or a combination of issues.
Absolute Pools can assess whether the pool needs a direct leak repair, crack repair, pipe repair, resurfacing, relining or a more complete repair approach.
Once the likely source of the leak has been identified, Absolute Pools can assist with the repair work needed to stop the water loss.
Some leaks can be repaired around fittings, weirs, pool lights, pipe joints or pump-area plumbing. Other leaks may need crack repairs, coping repairs, tile repairs, pipe repairs, resurfacing or relining if the pool finish is worn or damaged.
The right repair depends on the condition of the pool. A small fitting leak may only need a direct repair. An older pool with rough marbelite, recurring cracks, loose tiles or old patch repairs may need a more complete repair plan to prevent the leak from returning.
Repeated small repairs can become expensive when the real leak source is not understood. A wet patch near paving may be caused by underground water movement. A pump issue may point to suction-side plumbing. A visible crack may be only one part of a bigger pool condition problem.
Checking the symptoms properly helps reduce guesswork. It also helps prevent unnecessary opening of paving, replacing equipment that is not faulty, or applying patch repairs that do not solve the actual water loss.
For older pools, the repair plan should be practical. The aim is to stop the leak while also considering whether the pool surface, fittings or plumbing are likely to cause the same issue again.
Absolute Pools provides pool leak detection and pool leak repairs in Doringkloof and nearby Centurion areas.
We assist clients in Irene, Highveld, Clubview, Lyttelton, Eldoraigne, Zwartkop, Hennopspark, Southdowns, Eco Park, Rooihuiskraal, Valhalla and surrounding areas.
We also cover wider Gauteng areas, including Centurion, Pretoria, Midstream Estate, Johannesburg, Sandton, Midrand, Randburg and nearby suburbs.
Pool leaks are often connected to other swimming pool repair needs. Absolute Pools also assists with swimming pool repairs, pool renovations, pool resurfacing, pool relining, marbelite repairs, fibreglass pool repairs, pump repairs, filter repairs, chlorinator repairs and swimming pool construction.
If your leak is linked to old plumbing, cracked surfaces, damaged fittings, worn marbelite or failing pool equipment, we can recommend a practical repair route for your pool.
If your swimming pool is losing water, contact Absolute Pools for pool leak detection and pool leak repairs in Doringkloof and surrounding Centurion areas.
We can inspect the issue, identify the likely cause of the leak and advise on the right repair for your pool.